1. Record the relevant details of the pcb board
Take a pcb board and record the model, parameters, and positions of all components on the paper, especially the direction of the diode, the tertiary tube, and the direction of the notch. A digital camera can be used to take two photos of the component location. Many of the higher-level diode transistors of the circuit board copy board are not visible at all if they are not careful.
2. Scan the image
Take out all the equipment and remove the tin from the PAD hole. The pcb board is cleaned with alcohol and then put into the scanner. When scanning, the scanned pixels need to be slightly adjusted to obtain a clearer image. Gently sand the upper layer and the bottom with water gauze paper until the copper sheet is shiny, put it in the scanner, start the PS, and scan the two layers in in color.
3. Correct the image
Adjust the picture contrast and brightness to make the part with copper film and without copper film have a strong contrast, then change the second picture to black and white, and check whether the lines of the printed circuit board are clear. If it is not clear, repeat this step.
4. Check the position coincidence
Convert the two BMP format files into PROTEL format files and PROTEL files respectively. For example, PAD and VIA basically overlap the positions of PAD and VIA through the two layers, indicating that the previous steps have been done well. If there is a deviation, repeat the first step. Three steps. Therefore, it is very patience to copy the PCB circuit board, because a small problem on the circuit board will affect the quality and matching of the circuit board copy board.
5. Drawing layer
Convert the BMP of the TOP layer to TOPPCB, pay attention to the conversion to the SILK layer, which is the yellow layer, and then you are on the TOP layer, and place the device according to the drawing. After finishing drawing, delete the SILK layer. Continue to repeat until all layers are drawn.
6. Check
Check whether the electronic technical performance of the copy board is the same as that of the circuit board.










