Home > News > Content

PCBA Process Flow----OEM/ODM

Apr 20, 2022

In simple terms, the PCBA process is the combination of the SMT process and the DIP process. According to the requirements of different production technologies, it can be divided into single-sided SMT mounting process, single-sided DIP insertion process, single-sided mixed process, and single-sided paste. Mixed process of assembly and insertion, double-sided SMT placement process and double-sided mixed process, etc. The PCBA process involves the process of carrier board, printing, patch, reflow soldering, plug-in, wave soldering, testing and quality inspection, as shown in the figure below,

image

1. Single-sided SMT mounting

The solder paste is added to the component pads. After the solder paste printing of the bare PCB board is completed, its related electronic components are mounted by reflow soldering, and then reflow soldering is performed.


2. Single-sided DIP cartridge

The PCB board that needs to be plugged in is wave soldered after the electronic components are inserted by the production line workers. After the welding is fixed, the feet can be cut and the board can be washed. But wave soldering is less productive.


3. Single side mixed

The PCB board is printed with solder paste, and the electronic components are mounted and fixed by reflow soldering. After the quality inspection is completed, DIP insertion is performed, and then wave soldering or manual soldering is performed. If there are few through-hole components, manual soldering is recommended. .

image

4. Mixed single-sided placement and insertion

Some PCB boards are double-sided, one side is mounted and the other side is inserted. The process of placement and insertion is the same as that of single-sided processing, but the PCB board needs to use a jig for reflow soldering and wave soldering.


5. Double-sided SMT mounting

In order to ensure the aesthetics and functionality of the PCB, some PCB design engineers will use double-sided mounting. Among them, IC components are arranged on the A side, and chip components are mounted on the B side. Make full use of the PCB board space to minimize the PCB board area.

image

6. Double-sided mixing Double-sided mixing is equipped with the following two methods. The first method is to heat the PCBA three times, and the efficiency is low, and the red glue process wave soldering pass rate is low and is not recommended. The second method is suitable for the situation where there are many double-sided SMD components and few THT components, and manual soldering is recommended. If there are many THT components, wave soldering is recommended.


The above only simplifies the PCBA assembly process of the printed circuit board, and shows its process in the form of pictures and texts. However, as the PCBA assembly process and production process are gradually optimized, the failure rate is also continuously reduced, ensuring the production of high-quality finished products. The quality of the solder joints of all the electronic components mentioned above determines the quality of the PCBA board. Therefore, when relevant electronic manufacturers seek PCBA assembly and processing manufacturers, it is best to require rich experience and high level of processing equipment.


Send Inquiry